Description
- Single Workstation Continuous Monitor
- Continuously monitors the path-to-ground integrity of one operator, one ESD worksurface, and the electrical ground used to by the monitor.
- NEW Monitored Ground Terminal
- Provides a verified ground point for mats, carts, tools, and other items. Connect with the 09842 Multi-Ground Hub.
- NEW Light Tower Jack
- Connects with 19332 Light Tower Accessory
- NEW 19333 Power Relay Accessory
- Controls power to workbenches, hand tools, and other electronic devices dependent on the Full-Time Continuous Monitor’s status
- Wave Distortion Technology
- Provides stable continuous monitoring (versus pulsed or intermittent) of the wrist strap’s path-to-ground* and the presence of its 1 megohm safety resistor
- AC Outlet Monitor Circuit
- Verifies the wiring of an AC outlet and continuously monitors its path-to-ground integrity; fulfills the ANSI/ESD S6.1 section 6.3.1 requirement
- Park Delay Timer and ParkSnap™
- Indicates the 8 second delay to disconnect and park the operator wrist cord without creating a false alarm
- Embedded Relay Terminal
- Activates when a failure is reported by the monitor. Integrates with electronic locks, lights, and buzzers.
- Mat Monitor Switch
- Disables the worksurface monitor circuit when used in areas where there is no ESD worksurface
- Audible Alarm Adjustment
- Sets the audible alarm volume from loud to louder
- Enclosure with Mounting Tabs
- Installs in workbench and equipment environments
- Single-Wire Impedance Design
- Meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-0
- 1.2 Volt Operator Test Voltage
- Reduces the risk of electrical overstress (EOS) for the handling of sensitive components
- <50 Millisecond Alarm Response Time
- Identifies failures and intermittencies
- Continuous Visual and Audible Alarms
- Illuminates green to indicate proper grounding; illuminates red and sounds audible alarm when intermittent or failed connection occurs
- Calibration Verification Use the Desco 98221 Wave
- Distortion Monitor Verification Tester to check the test limits of Wave Distortion Monitors without removing them from their workstations
- NIST Calibrated – Original Calibration Certificate can be Downloaded
- Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology. For more information on the calibration of Desco products
- 100-240VAC Input with North American Power Cord
- Works with standard electrical systems in North America, Japan, and Asia
- Made in the United States of America
- This item is made and stocked in Chino, CA
