Continuously monitors the path-to-ground integrity of two operators and one ESD worksurface
Wave Distortion Technology
Provides stable continuous monitoring (versus pulsed or intermittent) of the wrist strap’s path-to-ground* and the presence of its 1 megohm safety resistor
IMPROVED Operator Alarm
Alarms when the operator unintentionally disconnects from the monitor or the connection between the banana plug and monitor’s jack is intermittent
NEW Park Delay Timer and ParkSnap™
Indicates the 8 second delay to disconnect and park the operator wrist cord without creating a false alarm
NEW Visual Status Display
Displays the operators’ and worksurface status: illuminates red when intermittent or failed connection occurs
NEW Mat Monitor Switch
Disables the worksurface monitor circuit when used in areas where there is no ESD worksurface
NEW Audible Alarm Adjustment
Sets the audible alarm volume from loud to louder
NEW 19333 Power Relay Accessory
Controls power to workbenches, hand tools, and other electronic devices dependent on the Dual Operator Continuous Monitor’s status
Single-wire Impedance Design
Meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-0
1.2 Volt Operator Test Voltage
Reduces the risk of electrical overstress (EOS) for the handling of sensitive components
<50 Millisecond Alarm Response Time
Identifies failures and intermittencies
Calibration Verification
Use the Desco 98221 Wave Distortion Monitor Verification Tester to check the test limits of Wave Distortion Monitors without removing them from their workstations
NIST Calibrated – Original Calibration Certificate can be Downloaded
Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology.
100-240VAC Safety Certified Power Adapter with North American Plug
Works with standard electrical systems in North America, Japan, and Asia
